Drip edge installation is a critical part of preventing water damage to your home’s fascia, and it’s an easy job that is completed in just a few hours.
This Titan Restoration & Construction guide will walk you through the process of installing drip edges so that you can protect your investment. Keep reading to learn more about drip edges and why they are so important!
What are Drip Edges?
Drip edges are small strips of metal installed along the edges of your roof. They serve two important functions: they direct water away from your home’s siding and protect the edge of your roof from water damage.
Drip edges are especially important in areas with high rainfall or snowfall, as they help prevent water seepage into your home from causing damage.
Why are Drip Edges Important?
Drip edges are an important part of protecting your home from water damage of a roofed origin. When water seeps into your home instead of dripping off to the side as designed, it can render a lot of damage to your home’s structure and cause rot in wooden frames, drywalls, and even brick & mortar structures.
Water damage is not only hideous, but it can also be expensive to repair. By installing drip edges, you can help to prevent water damage and keep your home looking its best.
How to Install Drip Edges
Installing drip edges is a relatively easy process completed in just a few hours. Following are the steps you will need to take to install drip edges:
Step # 1: Purchase Drip Edges:
First, you will need to purchase the drip edges. You can find these at most hardware stores or home improvement stores.
Step # 2: Measure and Cut the Drip Edges:
Then, using a ruler and knife, measure and cut the drip edges. You will want to make sure that the drip edges fit snugly against the sides of your home.
Step # 3: Clean Your Fascia Surface:
Before installing the drip edges, you must clean your fascia surface. It will ensure that the drip edges adhere properly. You can use a mild soap and water solution to clean the surface.
Step # 4: Nail or Screw it in Place:
Make sure that the drip edges are installed flush against the fascia. To secure the drip edges, fasten them with nails or screws. Use nails or screws suited for the material of your home.
Step # 5: Caulk any Gaps and seams:
Once the drip edge is in Place, caulk any gaps or seams to prevent water from seeping through. Allow for an ample amount of drying time before proceeding to the next stage.
Step # 6: Install the Gutters:
Now that the drip edge is installed, you can install the gutters. Begin by installing the gutter hangers onto the drip edge. Then, place the gutters into position and secure them in Place with the hangers.
Step # 7: Check for Leaks:
It’s crucial to check for leaks after the gutters have been installed. The last thing you want is water to seep in behind the drip edges and cause damage to your home.
So, what are you waiting for? If you’re in La Crosse, Wisconsin, and need a roofing or building firm that specializes in drip edge installation, Titan Restoration & Construction is ready to assist.
We offer free inspections and consultations, so don’t hesitate to contact us today!
